HL-4040CN

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I print on thick paper, labels and envelopes from the MP tray in Windows applications?  

Use the following steps for printing on thick paper, labels and envelopes.

 

  1. Choose the following from the printer driver:
    (1) Paper Size
    (2) Media Type
    (3) Paper Source
    and any other settings.

 

[PCL printer driver]

 

 

 

[BR-Script printer driver]
* BR-Script printer driver is available for HL-4050CDN and HL-4070CDW only.

 

 

 

  • To use the BR-Script printer driver you must install the driver using the Custom Install from the CDROM.
  • When you use Envelope #10, choose Com-10 for the Paper Size.
  • For other envelopes which are not listed in the printer driver, such as Envelope #9 or Envelope C6, choose User Defined....
 
  1. Open the MP tray and lower it gently.
  1. Pull out the MP tray support and unfold the flap (1).
  1. Lift up the support flap to prevent paper from sliding off the face-down output tray, or remove each page as soon as it comes out of the printer.
  1. Put paper in the MP tray. Make sure that the paper stays under the maximum paper mark (1).
  • Envelope joints that are sealed by the manufacturer should be secure.
  • The side to be printed on must be face up.
  • All sides of the envelope should be properly folded without wrinkles or creases.
 
  1. While pressing the paper-guide release lever, slide the paper guide to fit the paper size.
  1. Send the print data to the printer.
  • Remove each sheet or envelope at once after printing. Stacking the sheets or envelopes may cause the paper to jam or curl.
  • If envelopes get smudged during printing set the Media Type to Thick Paper or Thicker Paper to increase the fixing temperature.
 
  • When you put paper in the MP tray, remember the following:

     

    • Put the leading edge (top of the paper) in first and push it gently into the tray.
    • Make sure that the paper is straight and in the proper position in the MP tray. If it is not, the paper may not be fed properly, resulting in a skewed printout or a paper jam.
  • If DL size double flap envelopes are creased after printing, choose DL Long Edge in Paper Size, from the Basic tab. Put a new DL size double-flap envelope in the MP tray with the longest edge of the envelope in first, then print again.
 
 
 

If the printed envelopes have wrinkles, please try to change the direction of the flap when loading.

 

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

HL-4040CN, HL-4050CDN, HL-4070CDW

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.