QL-1100/1100c
 |
FAQs & Troubleshooting |
When I load a die-cut DK roll in my printer and turn it on, it does not feed any labels.
When loading a die-cut DK roll (such as DK-1234) through the Label Output Slot, make sure that the end of the first label is just visible.
If too much roll or too little roll is fed, the printer cannot read the sensor mark on it, and will not automatically feed the labels.
If your question was not answered, have you checked other FAQs?
Have you checked the manuals?
If you need further assistance, please contact Brother customer service:
Related Models
QL-1100/1100c, QL-1110NWB/1110NWBc
Content Feedback
To help us improve our support, please provide your feedback below.
