Model discontinued. This page is no longer updated.

PT-7500

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I make a label with a barcode?

Please follow the steps below:
 

  1. Set bar code parameters
    1. Press Code key, then Bar Code key.
    2. Press Left cursor key or Right cursor key until the parameter that you wish to change is displayed.
    3. Press Up cursor key or Down cursor key until the desired setting is displayed.
    4. Repeat the step "b" and the step "c" until all parameters are set as you wish.
    5. Press Enter key.

  2. Enter the bar code data
    1. Press Bar Code key.
    2. Type in the new bar code data or edit the old data.

  3. Add the bar code to the text
    1. Press Enter key to add the bar code to the text.

The following bar code parameters are available:

Parameter Settings
PROTOCOL CODE 39, I-2/5, EAN13, EAN8, UPC-A, UPC-E, CODABAR, EAN128, CODE128
WIDTH (bar width) SMALL, MEDIUM, LARGE
UNDER# (numbers printed below bar code) ON, OFF
CHECK DIGIT* OFF, ON

*The CHECK DIGIT parameter is available only with the CODE 39, I-2/5 and CODABAR protocols.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

PT-2470, PT-7500, PT-7600

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.