Innov-is F410

FAQs & Troubleshooting

FAQs & Troubleshooting
  • Date: 25/03/2022
  • ID: faqh00101590_001

"E08" message appears on the LCD. What does it mean?

 

Cause

This message is displayed when the Start/Stop button is pressed while the machine is set for the stitch width control.

 

 

Solution

Use the foot controller to operate the machine or turn off the width control function.
If you want to operate the machine with Start/Stop button, turn off the Width control function as follows.

 

  1. When the width control function is enabled, the img01 mark is displayed on the LCD screen as shown in the figure below.
    img02

     

     

  2. To disable the width control function, press the width control key img03 on the operation panel.
    img04

     

     

  3. The img05 mark on the LCD screen disappears and the width control function turn off.
    img06

     

  • Operation panel and operation keys vary depending on your machine model.
  • The page numbers vary depending on your machine model.

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

Innov-is F410

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit