DX70SE
 |
FAQs & Troubleshooting |
Machine does not start to sew.
If the machine does not start when you press the Foot controller, check the following possible causes and solutions.
-
The bobbin winder shaft is pushed to the right.
Slide the bobbin winder shaft to the left until it snaps into place.
Refer to "How do I wind the bobbin?".
-
Presser foot is not lowered.
Lower the presser foot.
Refer to "Basic procedure to sew stitches".
-
The foot controller was pressed with the buttonhole lever is down while a stitch other than a buttonhole stitch or a bar tack stitch is selected.
Raise the buttonhole lever before continuing the operation.
 |
(1) Buttonhole lever |
-
The foot controller was pressed with the buttonhole lever is up while a buttonhole stitch or a bar tack stitch is selected.
Lower the buttonhole lever before continuing the operation.
 |
(1) Buttonhole lever |
If your question was not answered, have you checked other FAQs?
Have you checked the manuals?
If you need further assistance, please contact Brother customer service:
Related Models
CS10s, CS120WTs, CS70s, DS120x, DX70SE, FS20s, FS45E, KE20s, X40s
Content Feedback
To help us improve our support, please provide your feedback below.
