SDX2250D

FAQs & Troubleshooting

FAQs & Troubleshooting

What Should I Do If the Material is not being Cleanly Cut by the Trimmer Blade?

 

Solution 1

 

While keeping the left edge of the material aligned with the rolled material guide, firmly press the trimmer down on the right side of the material. While holding them in place, slide the trimmer blade from right to left to cut off the material.

 
 

 【If the material is not very pliable】
   Firmly press the trimmer down on the right side  of the material

 

 【If the material is fairly pliable and has a strong curl】
    Firmly press the trimmer down at the center.

image (1) Rolled material guide
(2) Trimmer
(3) Trimmer blade

 

 

 

Solution 2

 

Clean the trimmer blade.
If lint or dust has accumulated in the trimmer blade, the material cannot be cut.
For details on cleaning, refer to Care and Maintenance (Cleaning the Trimmer Blade).
 

 

 

 

 

Solution 3

 

The trimmer blade may be worn.
Replace the trimmer blade with a new one.
 

 

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

SDX CE, SDX1000, SDX1200, SDX1250, SDX135, SDX1350, SDX1500, SDX1550, SDX2200D, SDX2240D, SDX2250D, SDX900, SDX950, SDX950SK, SDXTL

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.