CM600
FAQs & Troubleshooting |
What should I do if I turn off the machine after gluing?
If you turn off the machine after gluing, adhere the foil according to the following procedure.
Do not stick any material or debris on the exposed glue.
-
Pressin the operation panel to turn on the machine.If the mat has been inserted, the message appears on the display. Press OK to unload the mat.
-
Select "Pattern" in the home screen.
-
Select in the pattern category selection screen, and then select (BA-A001).
-
Unlocking the Aspect Ratio by pressing . After specifying the size, press "Set".
Ex
When you adhere the foil on the pattern 80 mm long by 90 mm wide, specify the size to about 90 mm long by 100 mm wide in the Pattern editing screen.
(1) 80 mm long
(2) 90 mm wide -
Move the pattern on the screen while confirming the glued position.
-
Press .
-
Select "Foil".
-
Select "Foiling".
-
Make sure that the pressing tool is set into the glue pen holder.
(1) Pressing tool
Place the foil on top of the pattern where the glue has been applied.
Place the protective sheet on the mat, and then secure it in place with commercially available tape, etc. -
Press "OK".
-
Load the mat in the same direction when gluing.
Start foiling by pressing Start / Stop button.
-
Feed out the mat, and then peel off the protective sheet and then carefully peel off the material from the mat.
-
Place the material on a level surface, and then slowly peel off the transfer sheet horizontally to the material.
-
Repeatedly dab the top of the foil with the dust removal sheet to remove any excess foil.
- Do not rub the foil with the dust removal sheet, otherwise the foil may become damaged.
- For storage, attach the dust removal sheet to its storage sheet in order to prevent it from being lost.