FS20s

FAQs & Troubleshooting

FAQs & Troubleshooting

Upper thread tightened up

Symptom

  • The upper thread appears as a single continuous line.
  • The bobbin thread is visible from the upper side of the fabric. (Refer to the illustration below.)
  • The upper thread has tightened up, and comes out when pulled.
  • The upper thread has tightened up, and wrinkles appear in the fabric.
  • The upper thread tension is tight, and the results do not change even after the thread tension is adjusted.
    img01 (1) Wrong side of fabric
    (2) Bobbin thread visible from right side of fabric
    (3) Upper thread
    (4) Right side of fabric
    (5) Bobbin thread

 

Cause

Incorrect bobbin threading

 

If the bobbin thread is incorrectly threaded, instead of the appropriate tension being applied to the bobbin thread, it is pulled through the fabric when the upper thread is pulled up. For this reason, the thread is visible from the right side of the fabric.

 

 

Remedy/check details

Correctly install the bobbin thread. Follow the steps below to correct the bobbin threading.

 

  1. Turn off the sewing machine.
     
  2. Raise the presser foot lever.

  3. Open the bobbin cover. Remove the bobbin from the bobbin case.

  4. Raise the needle to its highest position by turning the handwheel toward you (counterclockwise).
    img02

  5. Place the bobbin in the bobbin case so that the thread unwinds to the left.
    img03 (1) Bobbin case
  6. Hold the end of the thread, push the bobbin down with your finger, and then pass the thread through the slit, as shown.
    img04
     
  7. Reattach the bobbin cover.
    * Make the end of the thread come out from the left side of the cover.
    img05

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

FS20s

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.