CM840

FAQs & Troubleshooting

FAQs & Troubleshooting

The mat is fed in at an angle and is not fed during cutting / drawing.

Possible Causes (or Results)

 

  • The mat’s adhesive strength has decreased, or the material is not secured.
  • The material extends from the adhesive area of the mat.

 

Solutions

 

  1. Press the “Start/Stop” button to stop the operation.
     
  2. Follow the instructions on the screen, and press the “Feed” button img to feed out the mat.
    img

    If the mat does not feed out, turn off the machine (1), remove the holder (2), and then manually feed out the mat (3).

    img


     
  3. After feeding out the mat, replace it with a new one or attach the material while keeping it within the adhesive area of the mat.

    img
     

     

The cutting mats used by this machine have been redeveloped with a different design, type, function, etc.
For details, refer to Important information about Mat.

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

CM260, CM300, CM600, CM600DX, CM700, CM750, CM800Q, CM840, CM900

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.