MFC-L5750DW

FAQs & Troubleshooting

FAQs & Troubleshooting

Load and Print on Envelopes Using the MP Tray

You can load up to ten envelopes in the MP tray.

Before loading, press the corners and sides of the envelopes to make them as flat as possible.

When you load a different size and type of paper in the tray, you must change the Paper Size and Paper Type settings in the machine or on your computer, also.

  1. Open the machine's back cover (the face up output tray).
  2. Open the paper stopper (Available only for certain models).
  3. On the front of the machine, open the MP tray and lower it gently.
  4. Pull out the MP tray support (1) and unfold the flap (2).
  5. Slide the MP tray paper guides to fit the width of the envelopes that you are using. If the paper guide on the right side has a lever, press it and slide the paper guide.
  6. Load envelopes in the MP tray.
    Load up to 10 envelopes in the MP tray with the printing surface face up. Make sure the envelopes are below the maximum paper mark (1). Loading more than 10 envelopes may cause paper jams.
  7. Send your print job to the machine.
    Change your print preferences in the Print dialog box before sending the print job from your computer.
    Settings
    Options for Envelopes

    Paper Size

    Com-10

    DL

    C5

    Monarch

    Media Type

    Envelopes

    Env. Thick

    Env. Thin

  8. Close the paper stopper (Available only for certain models).
  9. Close the back cover (the face up output tray) until it locks in the closed position.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

DCP-L5500DN, DCP-L6600DW, MFC-L5700DN, MFC-L5750DW, MFC-L6800DW(T), MFC-L6900DW(T), MFC-L6950DW, MFC-L6970DW

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.