MFC-J5320DW

FAQs & Troubleshooting

FAQs & Troubleshooting

Load paper in the paper tray

Follow the steps below to load paper in the paper tray:
 

NOTE: Illustrations shown below are from a representative product and may differ from your Brother machine.
 

  1. Pull the paper tray completely out of the machine.
          
    Pull the paper tray
  2. If you are using Letter, A4, or smaller size paper, go to STEP 3.
    If you are using Legal, Ledger or A3 size paper, extend the paper tray.
    • When using Legal size paper
      Push the blue slider until it locks in the release position, and then extend the tray until the blue slider returns.
      Open the tray cover and make sure the triangular mark inside the tray (1) lines up with the mark (2) for B4 JIS/LGL, as shown in the illustration.
            
      Extend the paper tray
    • When using Ledger, or A3 size paper
      Push the blue slider until it locks in the release position, and then extend the tray until the blue slider returns. Repeat it again.
      Open the tray cover and make sure the triangular mark inside the tray (1) lines up with the mark (2) for A3/LGR, as shown in the illustration.
         
      Extend the paper tray
  3. Gently press and slide the paper guides (1) to fit the paper size. Make sure the triangular mark (2) on the paper guide (1) lines up with the mark for the paper you are using.
          
     Slide the paper guides
  4. Fan the stack of paper well to avoid paper jams and misfeeds.
        
    Fan the paper
  5. Gently load paper in the paper tray print side down. Make sure the paper is flat in the tray.
    NOTE: Load 148 x 210 mm (5.8 x 8.3 in.) or smaller size paper into the tray in portrait orientation.
    • When using Letter, A4 or Executive size paper
           
      Load paper
    • When using Ledger, Legal, or A3 size paper
            
      Load paper

      Be careful not to push the paper in too far; it may lift at the back of the tray and cause paper feed issues.
  6. Gently adjust the paper guides to fit the paper. Make sure the paper guides touch the edges of the paper.
        
    Adjust the paper guides
  7. Make sure the paper is flat in the tray and below the maximum paper mark (1). Overfilling the paper tray may cause paper jams.
        
    Make sure the paper is below the maximum paper mark
  8. Slowly push paper tray completely into the machine.
        
    Push paper tray
  9. Pull out or unfold the paper support flap.
    When using Ledger, Legal, or A3 paper When using Letter, A4 or smaller size paper
    Pull out paper support flap Pull out paper support flap
Position the machine so the tray will not protrude past the edge of the table or desk where someone may bump into it. The machine could fall and cause injury.
Position that tray is not protrudent

Position that tray is protrudent

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

MFC-J5320DW, MFC-J5620DW, MFC-J5625DW

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.