PR670E / PR670EC

FAQs & Troubleshooting

FAQs & Troubleshooting

Loops appear on the surface of the fabric when embroidering.

Check the following points or issues.

 

  • The upper thread tension is low.
     
    After passing the upper thread through the hole in the presser foot, pull the thread by hand to check the thread tension. If it is difficult to determine, compare it with other needle bars where looping does not occur.
     
  • The thread tension does not correspond to the amount that the thread tension knob or the upper thread guide pretension knob was tightened.
    If the thread tension cannot be adjusted, thread wax and dust may have collected in the upper or middle thread guide plates, causing the thread tension guide plates to rise. Clean the thread tension guide plates.

  • Thread is not correctly threaded around upper thread tension discs.
    Clean upper thread tension disc. Rethread and make sure tension disc rotates when pulling on thread.
     
  • The thread quality is poor.
    Try sewing with different thread.
    If the problem no longer occurs after the thread is changed, the thread quality is the problem. Replace the thread with one of good quality.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

PR1050X, PR1055X, PR670E / PR670EC, PR680W / PR680WC

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.