TD-4420TN

FAQs & Troubleshooting

FAQs & Troubleshooting

How to set the Gap/Black Mark Sensor as Media Sensor and calibrate the Gap/Black Mark Sensor by directly operating the printer

Follow the instructions below:

 

  1. Turn off the printer.

  2. Press and hold the Feed/Pause Button and then turn on the printer.

  3. For the Black Mark Sensor
    Release the button when the LED is lit in green/amber (blinks 5 times alternately) after the green LED flashes five times.
    The LED color will change in the following order:
    Amber > Red (5 times) > Amber (5 times) > Green (5 times) > Green/Amber (blinks 5 times alternately) (Release the button here) > Red/Amber (blinks 5 times alternately) > Green (lit)

    For the Gap Sensor
    Release the button when the LED is lit in red/amber (blinks 5 times alternately) after the green/amber LED flashes five times.
    The LED color will change in the following order:
    Amber > Red (5 times) > Amber (5 times) > Green (5 times) > Green/Amber (blinks 5 times alternately) > Red/Amber (blinks 5 times alternately) (Release the button here) > Green (lit)

    You can also calibrate by using the BPM (Brother Printer Management Tool).

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

TD-4420TN, TD-4520TN

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.