QL-810W/810Wc

FAQs & Troubleshooting

FAQs & Troubleshooting

Lines appear in areas with a high red density level.

If lines appear in areas with a high red density level as shown in the following labels, use the following procedure to resolve the problem.

Pattern A Pattern B

Pattern A

Pattern B

 

For pattern A:

  1. Make sure that the printer is turned off. Open the DK Roll Compartment Cover and remove the DK Roll from the printer.
  2. Close the DK Roll Compartment Cover completely.
  3. Press and hold the Editor Lite Button (QL-800/810W) or Cancel Button (QL-820NWB) for more than five seconds. Wait while the platen roller rotates.
  4. When the platen roller stops rotating, load the DK Roll.

To prevent this problem from occurring, perform one of the following procedures if you will not use the printer for a few days.

  1. Before printing, perform the procedure above to rotate the platen roller.
  2. When storing the printer, insert the protective sheet into the label output slot. The protective sheet was inserted into the label output slot when you purchased the printer.

For pattern B:

Pieces of paper may have adhered to the platen roller.

Use the cleaning sheet included with the printer to remove the pieces of paper.

For more information about using the cleaning sheet, see "What are the cleaning sheets for? When do I use them?".

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

QL-800, QL-810W/810Wc, QL-820NWB/820NWBc

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.