SDX325

FAQs & Troubleshooting

FAQs & Troubleshooting

How to Calibrate the LCD Touchscreen Display

If the screen does not respond correctly when you touch a key (the machine does not perform the operation or performs a different operation), follow the steps below to make the proper adjustments.


 

  1. Turn off the machine.

     
  2. Holding your finger on the LCD touchscreen display, turn on the machine.
    Keep your finger on the screen, until Brother logo disappears.

    image

    >> The touch panel adjustment screen is displayed.
     

    If you take off you finger too early, it will just load the normal screen “The carriage will move to......”.
    Turn off the machine, and try it again. Do not take off your finger on the screen until Brother logo disappears.



     
  3. The calibration screen appears.
    Using the included touch pen (stylus), lightly touch the center of each +, in order from 1 to 5.
    If an error occur when touching +, start again from number 1.
    image


    >> After completing the touch panel adjustment, the message “SUCCESS” appears on the screen.


     
  4. Turn the machine off, then on again.

    If you finish the screen adjustment and the screen still does not respond correctly, or if you cannot do the adjustment, contact the retailer who sold you this machine or Brother Customer Service.

     

     

     

     


     

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

SDX125, SDX125e, SDX125i, SDX225, SDX325, SDX85

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.