ES-2000/2000T

FAQs & Troubleshooting

FAQs & Troubleshooting
  • Date: 04/22/2013
  • ID: faqh00000068_000

An "E6" message appears on the panel.

Probable Cause:

 The motor locked up because the thread is tangled.

Solution:

 Remove the tangled thread before continuing the operation.

  Clean the bobbin case to remove the tangled thread.
  After cleaning the bobbin case, insert the bobbin case properly.
  If the needle is bent or broken, replace the needle.
  Then, thread the upper thread properly, and continue the operation.

 

 

Each time a key pressed or an incorrect operation is performed, a beep is sounded.

  • For a correct operation
    One beep is sounded.
  • If an incorrect operation is performed
    Two or four beeps are sounded.
  • If the machine locks up, for example, because the thread is tangled
    The sewing machine continues to beep for four seconds.
    The machine automatically stops.
    Be sure to check for the cause of the error, and correct it before continuing to sew.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

CE1000, CE-5000/5000PRW, CE5500T, CE6070T, CE8080/CE8080PRW, CP2410, CP-6500, CP-7500, CS-100T/4000/5000H, CS-6000/6000b/6000t/6000i, CS-8060, ES-2000/2000T, EX-660, HC3010, HC7140, Innov-is 40, Innov-is 40e, NX-200, NX-250, PC-210/210PRW, SC9500, SQ9050, SQ9130, XR6060, XR-7700, XS6060

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit