MFC-L9610CDN

FAQs & Troubleshooting

FAQs & Troubleshooting

Clean the Drum Unit

  • If your printout has black or white dots or other repeating marks at 3.7 in. (94 mm) intervals, the drum may have foreign material, such as glue from a label, stuck on the drum surface.

  • Before starting the cleaning procedure, see Related Information: Clean the Machine.

  1. Make sure the machine is in Ready Mode.
  2. Press image[Settings]>[All Settings]>[Print Reports]>[Drum Dot Print].
    image
    If your machine displays the [All Settings] menu on the Home screen, skip the [Settings] menu.
  3. Press [Yes].
    The machine prints the Drum Dot Check Sheet.
  4. Press image.
  5. Press and hold image to turn off the machine.
  6. Press the front cover release button and open the front cover.
    image
  7. Hold the drum unit's green labeled handle. Pull the drum unit out of the machine until it stops.
    image
    CAUTION
    We recommend placing the toner cartridge and drum unit assembly on a clean, flat surface with disposable paper underneath it in case you accidentally spill or scatter toner.
  8. Holding the green labeled handles of the drum unit, lift the front of the drum unit and remove it from the machine.
    image
    IMPORTANT

    Hold the handles of the drum unit when you carry it. DO NOT hold the sides of the drum unit.

    image
  9. Hold the handle of the toner cartridge and pull the toner cartridge up and out of the drum unit. Repeat this for all toner cartridges.
    image
  10. Turn the drum unit over by holding the green labeled handles. Make sure that the drum unit gears (1) are on the right side.
    image
  11. Use the column numbers next to the drum roller to find the mark. For example, a cyan dot in column 2 on the check sheet would mean that there is a mark in the “2” region of the cyan drum.
    image
    • K: Black
    • C: Cyan
    • M: Magenta
    • Y: Yellow
  12. Hold the drum unit frame with both hands, place your thumb on the drum unit gear, and roll the drum toward you by hand while looking at the surface of the suspected area.
    image
    image
    To avoid print quality problems, DO NOT touch any surface of the drum rollers except the drum unit gear.
  13. Wipe the surface of the drum gently with a dry cotton swab until the mark on the surface comes off.
    image
    NOTE
    DO NOT clean the surface of the photosensitive drum with a sharp object or any liquids.
  14. Turn the drum unit over by holding the green labeled handles.
  15. Reinsert the toner cartridge into the new drum unit. Make sure that you match the toner cartridge color to the same color label on the drum unit. Repeat this for all toner cartridges.
    image
    • K: Black
    • C: Cyan
    • M: Magenta
    • Y: Yellow
    image
    Make sure you put the toner cartridge in correctly or it may separate from the drum unit.
  16. Gently slide the drum unit into the machine until it stops.
    image
  17. Using the green labeled handle, push the drum unit back into the machine until it locks in place.
    image
  18. Close the machine's front cover.
  19. Press image to turn on the machine.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

MFC-L9610CDN

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.