Follow the steps below to replace the Fuser Cleaner.
The Fusing unit and the parts around it are HOT! Be sure to wait until the Fusing Unit has cooled sufficiently before replacing the Fuser Cleaner. If you touch the HOT parts, you might get injured.
Press the Power button to turn the printer off and wait until it has cooled down sufficiently.
Open the Top Cover.
Release the Oil Bottle Lock Levers on both sides as shown:
Take the Fuser Cleaner out of the Fusing Unit by holding the handle of the Fuser Cleaner as shown below.
Install the new Fuser Cleaner into the guide with the roller side facing you.
Lock the Fuser Cleaner with the Oil Bottle Lock Levers.
Close the Top Cover.
Press thePower button to turn the printer On.
Press any of the Menu buttons (+, -, Set or Back) to take the printer Off Line.
Press + or- until "RESET MENU" appears.
Press Set to proceed to the next menu level, and then press +or -until "PARTS LIFE" appears.
Press Set, and then press +. "FC ROLLER" appears.
Press Set, and then press Go. The printer is now in the READY state.
Si vous n'avez pas obtenu de réponse satisfaisante à votre question, avez-vous vérifié d'autres FAQ?
