LS-1217

Veelgestelde vragen en probleemoplossing

Veelgestelde vragen en probleemoplossing
  • Datum: 04/03/2009
  • Nummer: faqh00000438_000

How do I wind the bobbin?


  • Only use the bobbin that has been designed for this sewing machine.
    Using of any other bobbin may cause damage to the machine.
  • The bobbin was designed specifically for this sewing machine. If bobbins from older models are used, the machine will not operate correctly.

  1. Put the spool of thread on the spool pin. Make sure that the thread passes under the bobbin-winding tension disc.
    bobbin-winding tension disc and bobbin-winding shaft
    1 Bobbin-winding tension disc
    2 Bobbin-winding shaft

    If the spool of thread is not in the right place, the thread may tangle on the spool pin.

  2. Pass the end of the thread through the hole on the bobbin from the inside of the bobbin.
  3. Put the bobbin onto the bobbin-winding shaft and slide the bobbin-winding shaft to the right.
    Turn the bobbin clockwise, by hand, until the spring slides into the slit.
    bobbin 1 Spring

    2 Slit
  4. While holding the end of the thread, gently press the foot controller or press the start/stop button (for models equipped with the start/stop button) to wind the thread around the bobbin a few times.
    Then, stop the machine.
    While holding the end of the thread
  5. Trim the excess thread above the bobbin. Press the foot controller or press the start/stop button (for models equipped with the start/stop button) to start.
    continue winding the thread
  6. When the bobbin seems full and begins spinning slowly, take your foot off the foot controller or press the start/stop button (for models equipped with the start/stop button).
  7. After the machine stops, cut the thread, slide the shaft to the left, and then remove the bobbin.

    • The needle bar does not move after the bobbin-winding shaft is slid to the right.
    • Immediately after winding the bobbin, it is normal to hear the sound of the clutch engaging when beginning to sew or turning the balance wheel.

    Make sure you follow the instructions carefully.
    If you do not cut the thread completely, and the bobbin is wound, when the thread runs low it may tangle around the bobbin and cause the needle to break.

Verwante vragen

Staat het antwoord op uw vraag er niet bij, kijkt u dan eerst bij de andere vragen:

Heeft u de beschikbare handleidingen bekeken?

Heeft u meer hulp nodig, dan kunt u contact opnemen met de Brother-klantenservice.

Verwante modellen

LS-1217, LS-2125, XL-5130/5232/5340, XL-5500, XL-5600

Feedback

Geef hieronder uw feedback. Aan de hand daarvan kunnen wij onze ondersteuning verder verbeteren.

Stap 1: is de informatie op deze pagina nuttig voor u?

Stap 2: wilt u nog iets toevoegen?

Dit formulier is alleen bedoeld voor feedback.

Verzenden