HL-L6400DW

FAQs & Troubleshooting

FAQs & Troubleshooting

Set Sleep Mode Countdown

The Sleep Mode (or Power Save Mode) setting can reduce power consumption. Select how long the machine must be idle before it goes into Sleep Mode. The Sleep Mode timer is reset when the machine receives a print job.

When the machine is in Sleep Mode, it acts as if it is turned off. The machine will wake up and start printing when it receives a print job. Use these instructions to set a time delay (countdown) before the machine enters Sleep Mode.

HL-L5000D/HL-L5100DN/HL-L5200DW/HL-L6200DW

  1. Press or to select the [General Setup] option, and then press OK.
  2. Press or to select the [Ecology] option, and then press OK.
  3. Press or to select the [Sleep Time] option, and then press OK.
  4. Press or to enter the length of time, in minutes, that the machine should remain idle before entering Sleep Mode.
    Press Go.

HL-L6400DW

  1. Press [Settings]>[General Setup]>[Ecology]>[Sleep Time].
  2. Enter the length of time (maximum 50 minutes) the machine will remain idle before entering Sleep Mode, and then press [OK].
  3. Press .

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

HL-L5100DN, HL-L5200DW, HL-L6200DW, HL-L6400DW

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.