TJ-4020TN
 |
FAQs & Troubleshooting |
How to reset the printer settings by directly operating the printer
Printer initialization clears the printer's DRAM and restores its factory settings.
-
Turn off the printer.
-
Press and hold the Pause and Feed button, and then turn on the printer.
-
Release the button when the Power LED is blinking in green (5 times).
The LED color will change as follows:
Amber > red (5 times) > amber (5 times) > green (5 times) > green/amber (5 times) > red/amber (5 times) > green (lit)
After the initialization, the following factory settings will be restored:
| Parameter |
Default setting |
| Speed |
127 mm/sec (5 ips) (203 DPI)
76 mm/sec (3 ips) (300 DPI) |
| Density |
8 |
| Label Width |
101.5 mm (4") |
| Label Height |
101.5 mm (4") |
| Sensor Type |
Gap sensor: TJ-4020TN, TJ-4021TN, TJ-4120TN, TJ-4121TN
Black sensor: TJ-4021TNR, TJ-4121TNR |
| Gap Setting |
3 mm (0.12") |
| Print Direction |
0 |
| Reference Point |
0,0 (upper left corner) |
| Offset |
0 |
| Tear Mode |
On |
| Peeler Mode |
Off |
| Cutter Mode |
Off |
| Rewinder Mode |
Off |
| Code Page |
850 |
| Country Code |
001 |
| Clear Flash Memory |
No |
If your question was not answered, have you checked other FAQs?
Have you checked manuals?
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
