Innov-is A80

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I adjust a stitch width or length?

This machine is preset with the default settings for the stitch width and stitch length for each stitch. These settings can be changed as needed.

  • To return the settings to their defaults, turn off the machine, or select a different stitch.
     
  • If a straight stitch or triple stretch stitch is selected, changing the stitch width changes the needle position. Increasing the width moves the needle to the right;reducing the width moves the needle to the left.
  • After adjusting the stitch width, slowly turn the handwheel toward you (counterclockwise) and check that the needle does not touch the presser foot. If the needle hits the presser foot, the needle may bend or break.
     
  • If the stitches are bunched together, increase the stitch length. Continuing to sew with the stitches bunched together may result in the needle bending or breaking.

 

 

Setting the stitch width

The stitch width (zigzag width) can be adjusted to make the stitch wider or narrower.

 

img01

img02

When the stitch width is changed from the default setting, img03 around img04 disappears. When the stitch width is reset back to the default setting, img05 reappears around img06 .

 

 

 

Setting the stitch length

The stitch length can be adjusted to make the stitch coarser (longer) or finer (shorter).

img07

img08

When the stitch length is changed from the default setting, img09 around img10 disappears. When the stitch length is reset back to the default setting, img11 reappears around img12 .

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

Innov-is A80, Innov-is NV50S, TY600C

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.