DCP-J1200W(E)
FAQ & Fehlerbehebung |
Control Panel Overview
The control panel is an interface that allows the user to control the operation of a machine. It consists of buttons and LEDs that allow the user to set parameters, start and stop the machine and monitor its operation.
- (Paper)
Press this button to set the Paper Size and Paper Type settings.
- A4 LED/10 x 15 cm LED
Indicates the Paper Size and Paper Type setting selected.
|
(For printing standard documents) |
|
(For printing photos) |
|
Custom Settings |
-
Wi-Fi LED
- Indicates the wireless network status.
|
Connecting (Blinking) |
|
Connected (Lit) |
|
Disconnected (Blinking slowly) |
|
Off |
- Power LED
Indicates the machine's status.
-
MONO COPY
- Press to start making copies in monochrome.
- Press simultaneously with COLOUR COPY to start scanning documents (in colour or monochrome, depending on the scan setting).
- Press simultaneously with (STOP) to access the Reset Mode.
-
COLOUR COPY
- Press to start making copies in full colour.
- Ink LED
Indicates when the machine detects an ink error or is in Maintenance Mode.
- Warning LED
Indicates when the machine detects an error or is in Reset Mode.
-
(STOP) Power On/Off
- Press to stop an operation.
- Press to exit from a selected mode.
- Press (STOP) to turn on the machine.
Press and hold down (STOP) to turn off the machine and cancel all of the remaining operations. The Power LED blinks and stays on for a few seconds before turning itself off.
If you turn off the machine using (STOP), it will still clean the print head periodically to maintain print quality. To prolong print head life, provide better ink efficiency, and maintain print quality, keep your machine connected to a power source at all times.
-
(Wi-Fi)
- Press the button by itself or simultaneously with another button to configure the wireless settings or print network reports. Use only when the machine is idle.
- Press this button and COLOUR COPY simultaneously to restart the Wi-Fi if you cannot connect to your wireless network.
- Press simultaneously with (STOP) to access the Wi-Fi Mode.