CV3550

FAQs & Troubleshooting

FAQs & Troubleshooting
  • Date: 01/08/2017
  • ID: faqh00000586_003

How to attach and remove the presser foot

 

Always be sure to turn off the power before carrying out this operation.

 

  1. Turn off the main power and light switch or disconnect the power supply plug.
  2. Raise the presser foot lever (1).
  3. Turn the handwheel (2) so that the line on the handwheel is aligned with the line on the machine. (See Turning direction of handwheel )
  4. Push the button on the presser foot holder (3) to release the standard presser foot.
  5. Raise the presser foot farther by pushing the presser foot lever upward. Then, remove the presser foot and store it in a safe location.
  6. Again, raise the presser foot farther by pushing the presser foot lever upward. Place the presser foot just under the presser foot holder (A) so that the groove in the bottom of the presser foot holder (B) is aligned with the bar on the top of the foot (C), and then lower the presser foot lever to attach the foot (4).

image

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

CV3440, CV3550

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit