CV3550

FAQs & Troubleshooting

FAQs & Troubleshooting

Preparation before threading

When doing preparation before threading, turn off the machine for safety.

Thread tree

Raise the telescoping thread tree to its highest position. Make sure that the thread holders are in alignment above the spool pins as illustrated below.

image

(1) Thread holder on thread tree
(2) Spool pin
(3) Correct position

 

 

Thread spool

 

Using the thread spool cap

 

When using sewing thread spools, the thread spool cap should be used as illustrated below.
Make sure that the spool notch is on the bottom.

image

(1) Thread spool cap

 

  • Before using a thread spool, be sure to remove the spool cushion.

    image

     

  • Before using loosely spun nylon thread, be sure to install the spool cushion.

    image

    (1) Spool support
    (2) Spool cushion

     

  • If the thread spool cap is not fully pushed down, the thread may become entangled on the spool pin or the needle may bend or break.

 

Spool mat

 

When using thread spools or loosely spun thread that easily slips off the spool, place this mat under the spool.

This prevents the thread from becoming entangled on the spool pin.

image

 

 

Using the spool mat

 

  1. Remove the spool cushion, and then place the spool mat on the spool pin.
  2. Place the thread spool (with the spool notch at the bottom) on the spool pin, and then place the thread spool cap on top and fully push it down.

    image

    (1) Spool cushion
    (2) Thread spool cap
    (3) Spool support
    (4) Spool mat

    If the thread spool cap is not fully pushed down against the thread spool, the thread may become entangled on the spool pin or the needle may bend or break.

 

 

Using the thread net

 

If you are sewing with loosely spun nylon thread, we recommend that you cover the spool with the included net in order to prevent the thread from slipping off the spool.
Adapt the net to the shape of the spool.

image

(1) Thread net

 

 

Before threading

 

Needle position

 

Move the needles to their highest positions before threading.

 

  1. Turn off the main power and light switch for safety.

    image

  2. Raise the presser foot using the presser foot lever.

    image

  3. Turn the handwheel so that the line on the handwheel (A) is aligned with the line (B) on the machine. (See Turning direction of handwheel )

    image

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

CV3550

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.