TD-2130N

FAQs & Troubleshooting

Adding a custom media size for continuous tape (Linux®)

To add a custom media size for continuous tape, do the following:

Run the command to add a custom media size.
1. Add a new Label Format with the "New Label Format" name and set the 30mm width and length and the 3mm label gap:
  Example:
  "brpapertoollpr_td2020 -P TD-2020 -n Paper_Name -w 30 -h 30 -g 3.0 -b 3 -t 3 -r 1.5 -l 1.5 -S [0/1/2] [-m 0.0 -o 0.0]" [enter]
  (Type the whole command as a single line before you press enter):
  
  In the case of S=0,1 then program not need (-m 0.0 -o 0.0).
  
  -P Printer Name, e.g. TD-2020
  -n New Label Name
  -w label width
  -h label length
  -g label spacing
  -b bottom margin
  -t top margin
  -r right margin
  -l left margin
  -S 0/1/2(0:Continuous Length Tape/1:Die-Cut Label/2:Media With Marks)
  -m mark
  -o mark offset
  
  Example:
  brpapertoollpr_td2020 -P TD-2020 -n Paper_Name -w 30 -h 30 -g 3.0 -b 3 -t 3 -r 1.5 -l 1.5 -S [0/1/2] [-m 0.0 -o 0.0]
2. Remove the Label Format with the "New Label Format" name:
  "brpapertoollpr_td2020 -P TD-2020 -d Paper_Name" [enter]
  
  Enter the Width and Height/Length in mm.
  
  Superuser authorization is required.
Select the new media size from "Set Printer Options" in "http://localhost:631/printers".
Try a test print from "Print Test Page".

TD-2020/2020A, TD-2120N, TD-2125N, TD-2125NWB, TD-2130N, TD-2135N, TD-2135NWB, TD-2310D, TD-2320D, TD-2320DSA, TD-2350D

To help us improve our support, please provide your feedback below.