Innov-is BP3700

FAQs & Troubleshooting

FAQs & Troubleshooting

Using the embroidery needle plate cover

 

Under some conditions, based on the type of fabric, stabilizer, or thread being used, there may be some looping in the upper thread. In this case, attach the included embroidery needle plate cover to the needle plate. Attach the cover by inserting the two projections on the underside of the cover into the notches on the needle plate as shown below.

image (1) Groove
(2) Projection
(3) Notch

 

To remove the embroidery needle plate cover, place your fingernail in the groove and lift the plate out.

 

Push the embroidery needle plate cover as far as possible to attach it. If the embroidery needle plate cover is not securely attached, it may cause the needle to break.

 

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

Innov-is BP3600, Innov-is BP3700, Innov-is XE1, Innov-is XE2

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.