Innov-is NV180

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I attach or remove the embroidery frame ?


Attaching the Embroidery Frame

Wind and insert the bobbin before attaching the embroidery frame making sure to use the recommended bobbin thread. Check that there is enough thread in the bobbin.

 

  1. Raise the presser foot lever to raise the presser foot.


     
  2. Pass the embroidery frame under the presser foot.
    If necessary, raise the presser foot lever even further.

    img01


     
  3. Firmly insert the embroidery frame guide into the embroidery carriage frame holder from the top.
    Line up the embroidery frame guide tabs and the embroidery carriage frame holder slots and push in until it clicks and stops.
    img02 (1) Embroidery frame guide tabs
    (2) Embroidery carriage frame 
          holder slots
    >> The embroidery unit is attached.

    Correctly set the embroidery frame into the embroidery frame holder. Otherwise, the presser foot may hit the embroidery frame, resulting in injury.



     

Removing the embroidery frame

 

  1. Raise the presser foot lever to raise the presser foot.


     
  2. Press the part of the embroidery frame holder in the figure to the left side, and raise the embroidery frame.
    img03 (1) Lever

    >> The embroidery frame will separate from the embroidery frame holder.


     
  3. Remove the embroidery frame under the presser foot while raising the presser foot lever even further.

    img04

    Do not hit the needle with your finger or the embroidery frame. It may cause injury or needle breakage.


     

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

Innov-is M330E, Innov-is M370, Innov-is M380D, Innov-is NV180, Innov-is NV180D, Innov-is NV180K, Innov-is NV18E, LB6950, LB7950

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.