Innov-is BP3600
FAQs & Troubleshooting |
How do I attach the Embroidery foot “W+” with LED pointer or “W”?
- When attaching an embroidery foot, always press on the screen. You may accidentally press the [Start/Stop] button and possibly cause injury.
- Be sure to use embroidery foot W+ with LED pointer when doing embroidery. Using another embroidery foot may cause the needle to strike the embroidery foot, causing the needle to bend or break and possibly cause injury.
-
Press (Needle position button) to raise the needle.
-
Press to lock all keys and buttons.
If the message [OK to automatically lower the presser foot?] appears on the LCD screen, press [OK] to continue.Before replacing the needle, cover the hole in the needle plate with fabric or paper to prevent the needle from falling into the machine.
-
Raise the presser foot lever.
-
Remove the connector of the embroidery foot W+ with LED pointer from the connector on the back of the machine.
-
Use the included disc-shaped screwdriver to loosen the screw for the embroidery foot, and then remove the embroidery foot W+ with LED pointer.
-
Position the embroidery foot W+ with LED pointer on the presser foot bar by aligning the notch of the presser foot to the large screw.
Side view
-
Hold the embroidery foot in place with your right hand, and then use the disc-shaped screwdriver to securely tighten the screw for the embroidery foot.
(1) Screw for embroidery foot Use the disc-shaped screwdriver to firmly tighten the screw for the embroidery foot. If the screw is loose, the needle may strike the embroidery foot and possibly cause injury.
-
Plug the connector of the embroidery foot W+ with LED pointer into the jack on the back left side of your machine.
-
Press to unlock all keys and buttons.
>> All keys and operation buttons are unlocked, and the previous screen is displayed.
Content Feedback
To help us improve our support, please provide your feedback below.