FS60X

FAQs & Troubleshooting

FAQs & Troubleshooting

"E7" message appears on the LCD.

 

Cause

This message is displayed when an erroneous operation is performed as follows.

  • The operation button such as the Start/Stop button, the Reverse/Reinforcement stitch button or the Needle position button is pressed while the twin needle mode is active, and a stitch pattern that cannot be sewn with the twin needle is selected.
  • The foot controller is pressed while the twin needle mode is active, and a stitch pattern that cannot be sewn with the twin needle is selected.

img

(1) Needle mode indicator

img or img shows that the twin needle mode is selected.

 

 

Solution

  • When you want to sew a pattern you selected :

    Switch to the single needle mode, and replace the twin needle with a single needle before continuing the operation.

     

    To change the needle mode, follow the steps below.

    1. Turn off the machine.
       
    2. Holding down img (Plus key of the stitch selection keys (for digit in the ones place)), turn on the machine.

      img

    3. After the machine has turned on, release the key.
      The needle mode changes to the single needle mode.

      img

      (1) Needle mode indicator

      img or img shows that the single needle mode is selected.

       

     

     

  • When you want to sew with the twin needle :

    Select a pattern that can be sewn with the twin needle.

    Refer to "Stitch Chart" to learn stitches that can be sewn with a twin needle.

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

FS110X, FS40s, FS60X, FS80X

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.