Innov-is 400
![]() |
FAQs & Troubleshooting |
"Return the bobbin winding shaft to left." message appearing on the LCD. What does it mean?
The "Reverse/Reinforcement Stitch" button, "Needle Position" button or "Thread Cutter" button was pressed while the bobbin winder shaft is moved to the right.
Each time a key is pressed or an incorrect operation is performed, a beep is sounded.
-
For a correct operation
One beep is sounded. -
If an incorrect operation is performed
Two or four beeps are sounded. -
If the machine locks up, for example, because the thread is tangled
The sewing machine continues to beep for four seconds.
The machine automatically stops.
Be sure to check for the cause of the error, and correct it before continuing to embroider.
Related Models
CS-8120, Innov-is 1000, Innov-is 1200, Innov-is 1250, Innov-is 1250D, Innov-is 400, Innov-is 410, Innov-is 500D, Innov-is 600, Innov-is 610, Innov-is 700E, Innov-is 700EII, Innov-is 750D, Innov-is 750E, Innov-is 780D, Innov-is 900, Innov-is 90E, Innov-is 950, Innov-is 955, Innov-is 95E, Innov-is 980D, Innov-is 980K, Innov-is 985D, NX-400Q/400, NX-450, NX-600, NX-650, PE-150V, PE-190D, PE-770