FS101

FAQs & Troubleshooting

FAQs & Troubleshooting
  • Date: 22/04/2013
  • ID: faqh00000066_000

An "E5" message appears on the panel.

The start/stop button was pressed while the foot controller was connected.


Disconnect the foot controller, and then press the start/stop button.

Otherwise, operate the machine by using the foot controller.

 

 

Each time a key pressed or an incorrect operation is performed, a beep is sounded.

  • For a correct operation
    One beep is sounded.
  • If an incorrect operation is performed
    Two or four beeps are sounded.
  • If the machine locks up, for example, because the thread is tangled
    The sewing machine continues to beep for four seconds.
    The machine automatically stops.
    Be sure to check for the cause of the error, and correct it before continuing to sew.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

BC-2100/BC-2100PRW, BC-2500, CS-6000/6000b/6000t, CS-8060, DS-120, DS1300, DS-140, ES-2000, ES-2400, FS101, FS155, FS-20, FS50, FS70, Innov-is 20, Innov-is 200/200QE, Innov-is 210, Innov-is 30, Innov-is 35P, NS20, NS25, NS30/30LE, NS35, NX-200/200QE, NX-250, SL500

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit