Innov-is A80
 |
FAQs & Troubleshooting |
"E3" message appears on the LCD.
Cause
This message is displayed when an erroneous operation is performed as follows.
-
The Start/Stop button is pressed while the buttonhole or bar tack stitch is selected and the buttonhole lever is raised.
-
The Reverse/Reinforcement stitch button is pressed while the buttonhole or bar tack stitch is selected and the buttonhole lever is raised.
-
The foot controller is pressed while the buttonhole or bar tack stitch is selected and the buttonhole lever is raised.
Solution
Lower the buttonhole lever before continuing the operation.
If your question was not answered, have you checked other FAQs?
Have you checked the manuals?
If you need further assistance, please contact Brother customer service:
Related Models
FS110X, FS40s, FS60X, FS80X, Innov-is A50, Innov-is A80, Innov-is A80N, Innov-is C50PK, Innov-is NV50S, TY600C
Content Feedback
To help us improve our support, please provide your feedback below.
