XL-5500
![]() |
FAQs & Troubleshooting |
Why won't the machine pick up the bobbin thread?
There could be several things that could cause the machine not to pick up the bobbin thread.
- The upper thread could be tangled.
Remove the thread completely from the machine.
The correct size spool cap should be used for the size of the thread spool.
Re-thread the machine according to the directions in the manual.
One Point Advice Place a spool of thread on a spool pin.
One Point Advice Upper threading
- Remove the bobbin and make sure the bobbin is threaded properly in the shuttle race.
Remove any loose threads or lint in the shuttle race.
One Point Advice Installing a bobbin into a bobbin case
- You could be holding the needle thread too tight.
Hold the thread lightly to keep the end from going down into the shuttle.
- The needle could be thread incorrectly.
Thread the needle eye from the front to the back.
- The needle could be bent or improperly inserted.
Install a new needle with the flat side of the needle facing the back.
Related Models
BC-2100/BC-2100PRW, BC-2500, BM-3500/2600, BM-3600, CS-6000/6000b/6000t, DS-120, DS1300, DS-140, ES-2000, ES-2400, FS101, FS155, FS-20, FS50, FS70, LS-1217, LS-1520, LS-1717, LS-2000, LS-2125/2160, LS-2150, LS-2720, PX-100/200/300, Rose Wine, SF100, SF200, SF250, SF300, Vesta, Vesto, XL-2120/2220/2230/2240, XL-2600, XL-2600/2620/2630, XL3500, XL-5010/5020/5030, XL-5050/5060/5070, XL-5130/5232/5340, XL-5500, XL-5600, XL-5700
Content Feedback
To help us improve our support, please provide your feedback below.