Vesto

FAQs & Troubleshooting

FAQs & Troubleshooting

Why won't the machine pick up the bobbin thread?

There could be several things that could cause the machine not to pick up the bobbin thread.

 


  • The upper thread could be tangled.
    Remove the thread completely from the machine. 
    The correct size spool cap should be used for the size of the thread spool.
    Re-thread the machine according to the directions in the manual.

One Point Advice   Place a spool of thread on a spool pin. 

One Point Advice   Upper threading 

  • Remove the bobbin and make sure the bobbin is threaded properly in the shuttle race. 
    Remove any loose threads or lint in the shuttle race.

One Point Advice   Installing a bobbin into a bobbin case 

  • You could be holding the needle thread too tight.
    Hold the thread lightly to keep the end from going down into the shuttle.

  • The needle could be thread incorrectly.
    Thread the needle eye from the front to the back.

  • The needle could be bent or improperly inserted.
    Install a new needle with the flat side of the needle facing the back.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

BC-2100/BC-2100PRW, BC-2500, BM-3500/2600, BM-3600, CS-6000/6000b/6000t, DS-120, DS1300, DS-140, ES-2000, ES-2400, FS101, FS155, FS-20, FS50, FS70, LS-1217, LS-1520, LS-1717, LS-2000, LS-2125/2160, LS-2150, LS-2720, PX-100/200/300, Rose Wine, SF100, SF200, SF250, SF300, Vesta, Vesto, XL-2120/2220/2230/2240, XL-2600, XL-2600/2620/2630, XL3500, XL-5010/5020/5030, XL-5050/5060/5070, XL-5130/5232/5340, XL-5500, XL-5600, XL-5700

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.