MFC-L9670CDN

FAQs & Troubleshooting

FAQs & Troubleshooting

Clean the Corona Wires

Before starting the cleaning procedure, see Related Information: Clean the Machine.

  1. Press the front cover release button and open the front cover.
    image
  2. Hold the drum unit's green labeled handle. Pull the drum unit out of the machine until it stops.
    image
    CAUTION
    We recommend placing the toner cartridge and drum unit assembly on a clean, flat surface with disposable paper underneath it in case you accidentally spill or scatter toner.
  3. Hold the handle of the toner cartridge and pull the toner cartridge up and out of the drum unit. Repeat this for all toner cartridges.
    image
  4. Clean the corona wire inside the drum unit by gently sliding the green tab from left to right and right to left several times. Repeat this for all the corona wires.
    image
    image
    To avoid poor print quality, be sure to lock the green tab into the home position (1), flush left with the left side of the drum.
  5. Insert the toner cartridge into the drum unit. Make sure that you match the toner cartridge colour to the same colour label on the drum unit. Repeat this for all toner cartridges.
    image
    • K: Black
    • C: Cyan
    • M: Magenta
    • Y: Yellow
    image
    Make sure you put the toner cartridge in correctly or it may separate from the drum unit.
  6. Using the green labeled handle, push the drum unit back into the machine until it locks in place.
    image
  7. Close the machine's front cover.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

MFC-L9630CDN, MFC-L9670CDN

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.