HL-4040CN

FAQs & Troubleshooting

FAQs & Troubleshooting

Printouts have wrinkles.


Please check the following points:

  • Change to the recommended type of paper.

  • Make sure that the media type setting in the driver matches the type of paper you are using.
    To see what kind of media type you can use, click here.

  • Open the back cover and make sure that the two grey levers, one on the left-hand side and one on the right-hand side, are the same position.



    If you are using the envelope and it creases, pull down the two grey levers to envelope position. When you have finished printing, open the back cover and reset the two grey levers back to the original position.


  • Make sure that the back cover is closed properly.

  • Make sure that the drum unit is installed properly.

  • Make sure that the fuser unit is installed properly.

  • Replace the fuser unit. Call Brother Customer Service.

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

HL-4040CN

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.