Innov-is NV180

FAQs & Troubleshooting

FAQs & Troubleshooting

Bobbin thread breaks

When the bobbin thread breaks, check the following possible causes and solutions.

 

  • The bobbin thread was not set correctly.

    Reset the bobbin thread correctly.
    For details on setting the bobbin thread, refer to "How do I set the bobbin?".


     
  • Bobbin thread is incorrectly wound.

    Rewind the bobbin thread correctly.
    For details on  winding the bobbin, refer to "How do I wind the bobbin?".


     
  • There are scratches on the bobbin.

    Replace the bobbin with a new one.


     
  • The thread is tangled.

    Remove the tangled thread and clean the race.


     
  • A bobbin designed specifically for this machine is not used.

    Incorrect bobbins will not work properly.
    Be sure to use the included bobbins (part code: SA156, SFB: XA5539-151) or the same type.
    SA156 is Class 15 type bobbin.
    The bobbin's height is 11.5 mm (approx. 7/16 inch).
    img01 * Made of plastic
    (1) This model
    (2) Other models
    (3) 11.5 mm (approx. 7/16 inch)

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

Innov-is A150, Innov-is A16, Innov-is A80, Innov-is NV180, Innov-is NV18E

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.