Innov-is NV180

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I sew hook-and-loop fasteners(hook-and-loop tapes)?

  • Use only the adhesive-free hook-and-loop fastener tape which is designed for sewing. When the glue adheres to the needle or the bobbin case, it may cause malfunction.
  • If the hook-and-loop fastener tape is sewn with the thin needle (65/9-75/11), the needle may bend or break.
  • Before sewing, baste together the fabric and the hook-and-loop fastener tape.

Make sure that the needle passes through the hook-and-loop fastener tape by turning the handwheel and lower the needle into the hook-and-loop fastener tape before sewing. And then, sew the edge of the hook-and-loop fastener tape at a slow speed.
 


If the needle does not pass through the hook-and-loop fastener tape, replace the needle with the needle size for thicker fabrics. For details, refer to "Combination of fabric, thread and needle".

img01 (1) Edge of the hook-and-loop fastener tape

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

FS60X, Innov-is A150, Innov-is A16, Innov-is A80, Innov-is NV180

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.