Innov-is NV180

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I raise or lower the feed dogs?

The machine is equipped with the feed dog position switch to raise and lower the feed dogs.
When performing Button sewing or Free-motion quilting, use the feed dog position switch to lower the feed dogs.

The feed dog position switch is located at the rear of the machine on the base.

img01

(1) Feed dog position switch

 

 

 

Using the feed dog position switch to lower the feed dogs

  • Slide the feed dog position switch lever, located at the rear of the machine on the base, to (img02) (to the left as seen from the rear of the machine). The feed dogs are lowered.
    img03

 

 

  • After sewing is finished, slide the feed dog position switch lever to (img04) (to the right as seen from the rear of the machine) and turn the handwheel to raise the feed dogs.
    img05

 

 

The feed dogs can not be raised only by sliding the drop feed lever to img06 .

Raise the feed dogs as described below.

  1. Slide the feed dog position switch lever to img07 .
  2. Turn the handwheel toward you (counterclockwise), or press the Needle position button once or twice to raise the feed dogs.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

Innov-is A150, Innov-is A16, Innov-is A80, Innov-is NV180

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.