Innov-is 1250

FAQs & Troubleshooting

FAQs & Troubleshooting

Fabrics and stabilizer material for embroidery

Fabrics and stabilizer material for embroidery

 

Fabric Stabilizer material Reference
Type Material Top surface of fabric Underside of fabric

Medium weight fabrics Shirt/Apron

Cotton

Not required.

Attach a stabilizer by ironing.  

Thick fabrics
Jeans/Jumper

Denim
Quilting

Not required.

Attach a stabilizer by ironing.

It's better to place a stabilizer material on the top surface of fabric when you sew quilting.

Thin fabrics
Curtain/Liner

Georgette
Organdy

Place a stabilizer on.

Attach a stabilizer by ironing.

Temperature of iron should be "low".

Stretch fabrics
Sweatshirt/Vest

Knit
Jersey

Place a stabilizer on.

Attach a stabilizer by ironing.  

Towel cloth Towel

Towel
(pile)

Place a stabilizer on.

Place a stabilizer material under a fabric without attaching it and then hoop the fabric and the stabilizer together.

Caution:
If you attach stabilizer material to towels etc. by ironing, loops of the fabric might be expanded when removing the stabilizer.


 

  • Even though "Not required" is mentioned in the above list, use a stabilizer material for more attractive embroidery result if necessary.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

Innov-is 1200, Innov-is 1250, Innov-is 1500D/1500, Innov-is 4000D/4000, Innov-is 4500, Innov-is 700E, Innov-is 700EII, Innov-is 750E, Innov-is 900, Innov-is 90E, Innov-is 950, Innov-is 955, Innov-is 95E, Innov-is 980K, Innov-is I / Innov-is 6000D, Innov-is Ie, Innov-is V3, Innov-is V3 SE, Innov-is V7, PE-150V, PE-300S, PE-DESIGN 10, PE-DESIGN 11, PE-DESIGN 8, PE-DESIGN Lite, PE-DESIGN NEXT, PE-DESIGN PLUS, PE-DESIGN Ver.5, PE-DESIGN Ver.6, PE-DESIGN Ver.7, SuperGalaxie 3000/3000C/3000D/3100D

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.